Basic Beef Jerky

Posted By: Daniel Gasteiger  //  Category: food dehydrator, food dryer, food drying, jerky

Store-bought beef jerky comes in many varieties, and some are very tasty. However, jerky you make at home is likely to be far tastier than any you buy in a store. Today’s post includes a recipe for a simple jerky marinade with instructions for how to make beef jerky in your own food dryer.

Beef Jerky in a Food Dryer

Jerky is heavily-seasoned, dehydrated meat. Seasoning, salt, and sometimes other chemicals combine with dehydration to extend the meat’s shelf life and preserve its nutritional content. You can create a huge variety of seasoning combinations to create dozens of delicious jerky flavors, and making jerky is easy to do.

Historically, people dried meat over a fire or even by hanging it in direct sunlight. You can still do it that way if you wish, but using your oven is safer, and using a dedicated food dryer is even more efficient and less costly.

Considerations for Making Beef Jerky

Start with lean beef. Round steak and flank steak are good choices. Trim off all surface fat, and then put the meat in your freezer for an hour or longer until it becomes firm but not totally frozen.

While the meat cools, prepare the marinade (see box for a relatively standard recipe). You can also make sure your food dryer is clean and ready for use, but you won’t need it for another seven or more hours.

Beef Jerky Marinade for a Home Food Dryer

Use this recipe to marinade 2 pounds of thinly-sliced lean beef.

In a zipper-topped bag, mix 2 tablespoons of soy sauce and a tablespoon of Worcestershire sauce. Add a quarter teaspoon of ground black pepper, ½ teaspoon of onion powder, ¼ teaspoon of cayenne pepper, a teaspoon of table salt, and a teaspoon of liquid smoke.

Squeeze the bag repeatedly to mix the ingredients well, then add the beef. Kneed the marinade through the beef and then force as much air as you can out of the bag as you zip it closed. Ideally, the bag will seem vacuum-sealed and will cling to the meat it contains.

Store the bag in the refrigerator for 8 to 12 hours before dehydrating the jerky.

Remove the meat from the feezer and slice it very thin—a sixteenth to an eighth of an inch thick—across the grain. If you encounter sections of fat and connective tissue inside the meat, remove them.

Add the sliced meat to the prepared marinade and refrigerate it for six to 12 hours.

Into the Food Dryer

Remove the beef strips from the marinade and let them drain a bit before laying them out on your food dryer’s trays. It’s OK if the strips touch each other, but don’t let them overlap.

If your dehydrator has a temperature knob, set it at 150 degrees Fahrenheit and let the jerky dry for six hours. It’s ready when it’s dark and leathery; if you bend a piece it should crack but not break. If your jerky isn’t dry enough, continue dehydrating it for two more hours and so on until it passes the bending test.

How to Store Beef Jerky

When the jerky is done, turn off the food dryer and let the jerky cool to room temperature. At that point, loosen the pieces of jerky from the dehydrator trays but leave them for another 4 to 6 hours. Then move the jerky to an air tight container and store it in the refrigerator where it will keep for two or three months.

Technorati Tags: , , , ,

Making Beef Jerky

Posted By: Daniel Gasteiger  //  Category: food dehydrator, food dryer, jerky

While the embedded video in this post lacks some detail, it shows a simple, practical way to to make beef jerky using your oven a food dryer. If you have a dedicated dehydrator, skip the steps that show how to adapt your oven rack, and load up the trays of the dehydrator. Don’t overlap pieces of sliced meat on the trays; that could result in uneven drying.

If your dehydrator has a temperature setting knob, set it at 160 degrees Fahrenheit.

The video is only 2 and half minutes long. Please enjoy it.

How to Make Beef Jerky

Technorati Tags: , , ,